You can program your TiVo remote to turn your TV on and off, control the volume, and cycle through the TV input settings. How to Program a New TiVo Remote. TiVo Mini RF: if you need help pairing your remote, please see the 'TiVo Mini and Premiere Instructions' on this page.
Table of Contents Overview This article uses some terms that might be unfamiliar. Read through this list of terms and definitions if you need clarification: Operating Mode Description IR • Means Infrared • The remote relies on a direct line of sight to control the DVR • Does not require the remote to be paired to a specific DVR • Means Radio Frequency • Can control a DVR anywhere within a radius of approximately 30 feet • Remote needs to be paired to a specific DVR Pairing mode: RF remote controls support two methods for pairing: • New Pairing Mode • BOLT Series and Roamio Series are already in New Pairing Mode out of the box. • Pressing any button on any RF remote control will pair it. • Allow Pairing Mode (Remote) • Manually adding a new remote or transferring a remote to another device. • When it is in Allow Pairing Mode, it will pair with any compatible TiVo device accepting pairing requests in range. In Allow Pairing mode, the activity indicator LED (above the TiVo button) slowly flashes. When it successfully pairs with a DVR, the activity indicator LED flashes quickly five times and then stops.
Remote activity indicator colors and the signal they are sending. • If the activity indicator flashes red, the remote is sending IR commands to the DVR.
• If the activity indicator flashes amber, the remote is paired and is sending RF commands to the DVR. NOTE:Pairing-compatible TiVo device can be paired with up to 10 compatible remote controls at the same time.
However, each remote is limited to pairing to a single TiVo device. RF remotes work in IR mode. To enable RF communication, pair the remote to your TiVo device. See After you power up your BOLT Series and Roamio Series, press any button on an RF remote to pair it. NOTE: If you have multiple BOLT Unified Entertainment System/Roamio Series devices, set them up one at a time to ensure that each remote pairs to the correct Unified Entertainment System/DVR. In New Pairing Mode, when you press a button, the remote control sends out an IR signal that: • Performs the command you requested • Requests pairing with any unpaired BOLT Unified Entertainment System/Roamio Series devices within range See Operating Mode Key Combination Switch to IR Hold down TiVo + Red C buttons until the activity indicator LED blinks red 3 times.
Switch to RF Hold down the TiVo + Green D buttons until the activity indicator LED blinks amber 3 times. To control your TiVo device with a different remote or transfer the remote to another device, perform the steps below. NOTE: • This step is a back door and should only be used to clear pairing of ALL remote controls. • This will put the TiVo device into new mode and it will pair the first remote control it detects, either Roamio or voice remote.
If performed with a paired remote control, it will also unpair that remote control. • Hold down TiVo + Back on the remote until the TiVo mascot's antennae blink amber (the remote is now ready to pair with the DVR). • Now press any button on the remote and confirm that the TiVo mascot's antennae blink amber with each button press. • The remote is now paired in RF mode with the DVR. This unpairs the RF remote from the paired TiVo device, then clears any other remote settings, such as IR codes for your television or other A/V device. IMPORTANT: You will need both the paired RF remote and your TiVo device to perform a global reset. The Witches Roald Dahl Pdf.